dnorris78 Posted December 12, 2016 at 07:21 PM Report Share Posted December 12, 2016 at 07:21 PM I have a new 2017 FFE Titanium. This replaced a 2013 FFE SE model that was totaled. In my 2013 FFE the Go Times and preconditioning was problematic. On cold winter days the go times would be set at 85 but the cabin never reached that temp or even close. Now in my 2017 model the same issue exists. Using Go Times is pointless since I am not getting the cabin to warm at all hardly. Oh and the car is plugged into a Level 2 charger at home. Does anybody have an suggestions? On a cold morning I can remote start the car and it warms the cabin fine but it also eats up battery. Quote Link to comment Share on other sites More sharing options...
murphy Posted December 12, 2016 at 07:44 PM Report Share Posted December 12, 2016 at 07:44 PM (edited) Are you setting the GO time for the time that you want to leave? It starts heating 30 minutes before that time. It works fine in my 2013 using a 240 volt EVSE. Edited December 12, 2016 at 07:47 PM by murphy Quote Link to comment Share on other sites More sharing options...
dnorris78 Posted December 12, 2016 at 08:18 PM Author Report Share Posted December 12, 2016 at 08:18 PM Yes. Go time is set for when I want to leave. Quote Link to comment Share on other sites More sharing options...
jeff_h Posted December 12, 2016 at 08:27 PM Report Share Posted December 12, 2016 at 08:27 PM Yes. Go time is set for when I want to leave. I think the HVAC also continues for up to 10 minutes after the set time, so I have the Go Times on my wife's car set to 10 minutes before she leaves and that gives a few extra minutes - but the Go Times for pre-heating and pre-cooling on her car were always great... Quote Link to comment Share on other sites More sharing options...
dnorris78 Posted December 12, 2016 at 09:25 PM Author Report Share Posted December 12, 2016 at 09:25 PM Found the problem. I was looking to make sure that the clock in the car was correct and went to go times in Sync 3. There is a "Disable/Enable" setting for Go Times. Pics attached jeff_h 1 Quote Link to comment Share on other sites More sharing options...
murphy Posted December 12, 2016 at 09:33 PM Report Share Posted December 12, 2016 at 09:33 PM Found the problem. I was looking to make sure that the clock in the car was correct and went to go times in Sync 3. There is a "Disable/Enable" setting for Go Times. Pics attachedI forgot about that little detail. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.