Search the Community

I have been reading up in forums and online on the quest for the perfect charger. There are just so many great choices available out there for chargers. In the end I decided to go with the JuceBox Pro 40 amp charger. I chose this unit since it has WIFI and an android application. Reflecting back I would have not purchased this WIFI unit again. I should have spent the $50 more for the "smart" WIFI to determine when "Clean Coal" is charging the car. I found the installation to be straight forward without major complications (more work went into installing the outlet). This job only required a drill and a screwdriver for the bracket. I like the fact that this unit is 40 amps and can handle a lot more car down the road. Probably the most complicated part was getting the JuiceBox to communicate with the home WIFI. Then again it took me over 30 minutes to get the car to communicate with my WIFI. I will keep people posted on how the unit is functioning and if the long haul value is there. Also, I like to support the smaller business owners who have a product that is assembled in the USA with forigen parts (see later post for the exact ratio). This product meets those requirements and the support has been great also. Now on to the unboxing / installation: The box was smaller than expected for the charging unit. I was surprised that the unit came in less than two days. I ordered direct from the website http://www.emotorwerks.com. I I had a few questions prior to ordering and they where quick to get back to me. Started to open up to see the content. I spent extra for the licence plates ($7.99). I probably just ordered all of it for the plate frame. :spend: Finished removing the unit and parts from the box. Comes with a wall bracket, unit bracket, Plug (14-50p RV plug), charging cable, charging cable bracket. Easy to follow instructions with photos and a charging etiquette hanger. The hanger goes on when traveling to public chargers. The other side is the opposite saying not unplug. Installed the fancy bracket to the wall. I had to add one more screw for the bottom of the JuiceBox. Here is the bracket for the back of the JuiceBox (third mount point). Bracket mounted to the rear of the unit. Doing a dry run to see if everything is looking good. How it looks fully complete and installed. I do not have any photos from the WIFI setup. Also, the unit is portable for trips I would just need to get some adapters.